Printable Reference Card

Pressure Washer Task Pressure Reference

One-page reference card with recommended PSI, GPM, tip color, detergent need, and time per 100 sq ft (9.3 m²) for 18 common surfaces and tasks. Print on cardstock or laminate and keep next to the machine.

Pair with the Pressure Washer PSI & GPM Calculator for task-specific live recommendations and the how to choose a pressure washer guide for the buying-and-technique walkthrough. Run gutter cleaning safely with the how to clean your gutters safely guide and log every session in the Home Maintenance Log.

Frequently Asked Questions

How do I use this reference card?

Print on cardstock or laminate, then keep next to the pressure washer. Before each session, look up the surface in the table to confirm the right PSI range, GPM, tip color, and detergent need. The PSI numbers are working ranges (low end gentle, high end aggressive); start at the low end on any surface you have not cleaned before. Pair with the Pressure Washer PSI & GPM Calculator for task-specific recommendations and the how to choose a pressure washer guide for the longer-form context.

What are the tip color codes?

Five color-coded tips ship with most residential pressure washers. Red (0 degree, never on residential), yellow (15 degree, hardscape), green (25 degree, general purpose), white (40 degree, soft surfaces), black (low-pressure detergent). Always start with the widest angle (white 40) on any new surface and step down only if needed. Tip color is the single most important factor in damage prevention; PSI is secondary.

Why does the table show PSI ranges instead of single numbers?

Each surface has a working range, not a single right number. The low end is gentle (longer time, no risk); the high end is aggressive (faster, but closer to damage threshold). Real-world variables (paint condition, surface age, mildew load, distance from tip, detergent dwell time) all shift the right number within the range. Start at the low end and increase pressure only if necessary. Most homeowners under-clean by staying too low; some over-clean by jumping straight to the high end.

What if I’m cleaning a surface not in the table?

Match by material first, then by hardness. A surface not listed but similar to listed material follows that material’s settings. When in doubt, start with white 40-degree tip and 1,200 PSI; that is universally safe for first-pass testing. Step up only if the lower setting leaves dirt. The Pressure Washer PSI & GPM Calculator handles edge cases not on the printable card.