Frequency Sweep Test (20Hz–20kHz)
Sweep through the audible frequency range to test headphones, speakers, bass response, treble clarity, and possible audio dropouts.
Start test
What to listen for
- Buzzing, rattling, or distortion at certain frequencies
- Sudden volume drops or dead spots
- Weak bass or weak treble
- Imbalance between left and right speaker setups
- Harsh peaks that may point to resonance issues
Quick test guide
- 20Hz–80Hz: deep bass and rumble
- 80Hz–250Hz: bass body and punch
- 250Hz–2kHz: mids and vocal body
- 2kHz–6kHz: presence and clarity
- 6kHz–20kHz: treble sparkle and air
If something sounds wrong
- Try lower volume first
- Test another browser or device
- Compare headphones vs speakers
- Run the Speaker Left / Right Test
- Check cable connections and EQ settings
Common mistakes
- Starting at high volume. A sweep concentrates energy, and the low and high extremes can be painful or stress small drivers. Start near 20% and raise slowly.
- Reading loudness as response. Your ears are far less sensitive at the extremes, so quiet bass and quiet treble are usually normal hearing, not a fault.
- Blaming the speaker for room rattle. A buzz at one frequency is often a loose object or panel nearby, not the driver. Mute and hunt for the vibrating item.
- Expecting deep bass from tiny drivers. Most earbuds and laptop speakers roll off below about 50Hz. Missing sub-bass there is expected, not a defect.
- Skipping the channel check. If one side sounds weak across the whole sweep, run the Left / Right test first to isolate a channel problem.
FAQ
What frequency range should I be able to hear?
Healthy young adults hear roughly 20Hz to 20kHz. The upper limit drops with age, and most adults over 40 stop hearing above about 14 to 16kHz. Not hearing the very top of the sweep is normal and not a speaker fault.
Why does the bass sound quiet even at full sweep?
Two reasons. Small drivers in laptop speakers and earbuds physically cannot move enough air for deep bass, and human hearing is naturally less sensitive to low frequencies. Quiet sub-bass on small devices is expected.
Can a frequency sweep damage my speakers or hearing?
At sensible volume, no. At high volume, a sustained tone at a driver's resonant frequency can stress it, and loud high-frequency tones are uncomfortable. Keep the volume low, especially on the bass and treble sweeps.
Is this a substitute for a real frequency-response measurement?
No. A true response curve needs a calibrated microphone and software. This sweep is a quick by-ear check for dropouts, buzzing, and obvious weak spots, not a measurement.